Skip to main content

Xraycam

The new X-ray Beam Camera

SPECIAL INTRODUCTION OFFER VALID UNTIL 01/2025

2,400 EUR - 18.3 % discount = 2,000 EUR

raycam: X-ray beam camera
Side view
raycam: X-ray beam camera
Side view with magnetic holder arm
raycam: X-ray beam camera
Camera + arm + magnetic base
raycam: X-ray beam camera
Complete package with suitcase
    The Xraycam is a high resolution CMOS camera coupled to a screen that converts X-rays into visible light. It will show an image of the direct X-ray beam in 25 fold magnification on a smartphone, tablet or PC monitor.

    Xraycam   vs.  marcam

    The Xraycam is a complete new development introduced in 2024. It is a full replacement for the   marcam   that has been in use for 25 years. Thanks to new imaging technologies, the new camera outperforms the previous instrument in every single aspect.

    CAMERA CHIP

    The Xraycam comes with a 12MP CMOS chip with 4000x3000 pixels. The marcam has a plain 0.5 MP CCD camera chip with 640x480 pixels.

    FIELD OF VIEW

    Approx. 30 x 20 mm for Xraycam and 25 x 18 mm for the marcam

    SPATIAL RESOLUTION

    The high resolution sensor of the new Xraycam offers much finer detail of the beam. Both pictures shown below were taken under the same conditions on a microsource generator operated at 20 Watt.

    Xraycam marcam

    INTERFACE

    The Xraycam comes with a modern USB-C interface that connects to a PC, smartphone or tablet without needing drivers. You can therefore use monitors from conventional devices to look at the beam. The marcam, in contrast, came with a coaxial BNC connector that required special monitors.

    Highlights

    NO X-RAY LEAKAGE

    The Xraycam comes with a set of adapters, that allow you to couple it directly to the X-ray optics to be aligned. The beam is completely enclosed and the user does not risk exposure to scattered X-rays.

    INDEPENDENT OF AMBIENT LIGHT

    Since the camera displays the image of the beam on a monitor, there is no reason to turn the room lights off. Alignment procedures can be completed in adequate lighting to see small parts.

    ACCESSORIES

    The Xraycam is shipped in a compact suitcase. It includes the camera unit and several adapters for use with different X-ray optics . We also add a versatile magnetic stand to the package as well as am USB-C cable and an adapter for mobile devices. And as bonus a nice holder for smartphones or tablets.

    MANY APPLICATIONS

    The Xraycam replaces the older marcam as well as fluorescent paddles and pin diodes. It is useful for aligning monochromators, multilayers and focusing mirrors. It can also be used to check the focus of a rotating anode or metaljet generator.

    X-RAY SAFETY

    The camera eliminates X-ray scatter and leakage during the alignment procedure. It also frees the hand that traditionally holds the fluorescent paddle. Since the image is displayed on a monitor, there is no need to lean into the radiation enclosure and get close to the beam to see the result of adjustments.

    25-FOLD MAGNIFICATION

    The large image displayed on a monitor makes it much easier to observe the effect of alignment adjustments when working with mirrors. The user can confidently choose the double diffracted beam and obtain maximum intensity and purity with certainty. This also makes the camera a good teaching tool.

    AFFORDABLE

    The Xraycam is priced to replace your marcam, pin diode or fluorescent paddle. Contact us for a quote based on your specific needs.

    Downloads